And introduce two new directives for ui tests:
* `run-crash`
* `run-fail-or-crash`
Normally a `run-fail` ui test like tests that panic shall not be
terminated by a signal like `SIGABRT`. So begin having that as a hard
requirement.
Some of our current tests do terminate by a signal/crash however.
Introduce and use `run-crash` for those tests. Note that Windows crashes
are not handled by signals but by certain high bits set on the process
exit code. Example exit code for crash on Windows: `0xc000001d`.
Because of this, we define "crash" on all platforms as "not exit with
success and not exit with a regular failure code in the range 1..=127".
Some tests behave differently on different targets:
* Targets without unwind support will abort (crash) instead of exit with
failure code 101 after panicking. As a special case, allow crashes for
`run-fail` tests for such targets.
* Different sanitizer implementations handle detected memory problems
differently. Some abort (crash) the process while others exit with
failure code 1. Introduce and use `run-fail-or-crash` for such tests.
According to
https://discourse.llvm.org/t/rfc-volatile-access-to-non-dereferenceable-memory-may-be-well-defined/86303/4,
LLVM allows volatile operations on null and handles it correctly. This
should be allowed in Rust as well, because I/O memory may be hard-coded
to address 0 in some cases, like the AVR chip ATtiny1626.
A test case that ensured a failure when passing null to volatile was
removed, since it's now valid.
Due to the addition of `maybe_is_aligned` to `ub_checks`,
`maybe_is_aligned_and_not_null` was refactored to use it.
docs: revise restrictions on volatile operations
A distinction between usage on Rust memory vs. non-Rust memory was
introduced. Documentation was reworded to explain what that means, and
make explicit that:
- No trapping can occur from volatile operations;
- On Rust memory, all safety rules must be respected;
- On Rust memory, the primary difference from regular access is that
volatile always involves a memory dereference;
- On Rust memory, the only data affected by an operation is the one
pointed to in the argument(s) of the function;
- On Rust memory, provenance follows the same rules as non-volatile
access;
- On non-Rust memory, any address known to not contain Rust memory is
valid (including 0 and usize::MAX);
- On non-Rust memory, no Rust memory may be affected (it is implicit
that any other non-Rust memory may be affected, though, even if not
referenced by the pointer). This should be relevant when, for example,
reading register A causes a flag to change in register B, or writing
to A causes B to change in some way. Everything affected mustn't be
inside an allocation.
- On non-Rust memory, provenance is irrelevant and a pointer with none
can be used in a valid way.
fix: don't lint null as UB for volatile
Also remove a now-unneeded `allow` line.
fix: additional wording nits
* The WASI targets deal with the `main` symbol a bit differently than
native so some `codegen` and `assembly` tests have been ignored.
* All `ignore-emscripten` directives have been updated to
`ignore-wasm32` to be more clear that all wasm targets are ignored and
it's not just Emscripten.
* Most `ignore-wasm32-bare` directives are now gone.
* Some ignore directives for wasm were switched to `needs-unwind`
instead.
* Many `ignore-wasm32*` directives are removed as the tests work with
WASI as opposed to `wasm32-unknown-unknown`.
